Omron C200HX Operation Manual page 500

Host Link Commands
Response Format
Limitations
PC Settings
Execution Conditions
End Codes
10-3-21 SV CHANGE 2 –– W$
Command Format
1 0
x 10 x 10
@ W
Node no. Header
code
482
x 10
@
Node no.
The command can't be executed unless the SV is BCD from 0000 to 9999.
The command can't be executed if the UM area is write-protected.
If the same instruction is used more than once in a program, the SV of the first
one will be changed.
PC Mode
RUN MONITOR
--- OK
Commands
Single
OK
An end code of 14 (format error) will be returned if the length of the command is
incorrect.
An end code of 15 (entry number data error) will be returned if the SV isn't BCD or
the mnemonic/TC number is incorrect.
An end code of 16 (command not supported) will be returned if the specified
instruction doesn't exist in the program.
End code
00 Normal completion
01 Not executable in RUN mode
13 FCS error
14 Format error
15 Entry number data error
16 Command not supported
18 Frame length error
23 User memory protected
Changes the contents of the second word of the TIM, TIMH(15), CNT,
CNTR(12), or TTIM(87) at the specified program address in the user's program.
This can only be done with a program of less than 10K.
3 2 1 0
x 10 x 10 x 10 x 10 OP1
$
Program
address
OP1 OP2
1 0 1
x 10 x 16 x 16
W #
Header End code
code
PROGRAM Write-protected
OK
Multiple
---
Contents
3
OP2 OP3 OP4 x 10
Mnemonic Timer/counter
(0000 to 0511)
3 2
OP3 OP4 x 10 x 10
Operand SV
Section 10-3
0  ↵
FCS Terminator
UM Area
Read-protected
--- OK
Responses
Single Multiple
OK ---
2 1 0
x 10 x 10 x 10
1 0 
x 10 x 10
FCS Terminator
↵