Omron C200HX Operation Manual page 501

Host Link Commands
Response Format
Limitations
PC Settings
Execution Conditions
End Codes
Use all four characters to specify the timer or counter instruction's mnemonic.
Add a space to the end of a TIM or CNT mnemonic to make it 4 characters long.
Instruction name
TIMER
HIGH-SPEED TIMER
COUNTER
REVERSIBLE COUNTER
TOTALIZING TIMER
The "Operand" parameter indicates the data area where the SV is stored or a
constant. The "SV" parameter indicates the word address or the SV itself if it is a
constant.
Operand
OP1 OP2 OP3
C I O
L R (Space)
H R (Space)
A R (Space)
D M (Space)

D M
C O N
E M (Space)

E M
1
x 10 x 10
@
Node no.
The command is valid only when the UM setting is ladder only.
SR 253 through SR 255 can't be specified.
The command can't be executed if the UM area is write-protected.
PC Mode
RUN MONITOR
--- OK
Commands
Single
OK
An end code of 14 (format error) will be returned if the length of the command is
incorrect.
An end code of 15 (entry number data error) will be returned if the program ad-
dress isn't BCD, the program address exceeds the maximum address in the pro-
gram, the mnemonic/TC number is incorrect, or the SV is incorrect.
An end code of 16 (command not supported) will be returned if the specified
instruction doesn't exist in the program.
End code
00 Normal completion
01 Not executable in RUN mode
Mnemonic
OP1 OP2 OP3
T I M
T I M
C N T
C N T
T T I
Classification
OP4
(Space) IR or SR
(Space) LR
(Space) HR
(Space) AR
(Space) DM
(Space) DM (indirect)
(Space) Constant
(Space) EM
(Space) EM (indirect)
0 1 0
x 16 x 16
W $
Header End code
code
PROGRAM Write-protected
OK ---
Multiple Single
--- OK
Contents
Section 10-3
TC number
range
OP4
(Space) 0000 to 0511
H
(Space)
R
M
Constant or
word address d dd
0000 to 0511
0000 to 0063
0000 to 0099
0000 to 0027
0000 to 6655
0000 to 6655
0000 to 9999
0000 to 6143
0000 to 6143
 ↵
FCS Terminator
UM Area
Read-protected
OK
Responses
Multiple
---
483