Main Menu - Data Readouts - Group - Danfoss VLT AQUA Programming Manual

®
VLT AQUA Drive Programming Guide
15-99 Parameter Metadata
Array [23]
*
0

2.15. Main Menu - Data Readouts - Group 16

2.15.1. 16-** Data Readouts
Parameter group for data read-outs, e.g. actual references, voltages, control, alarm, warning and
status words.
2.15.2. 16-0* General Status
Parameters for reading the general status, e.g. the calculated reference, the active control word,
status.
16-00 Control Word
Range:
*
0
16-01 Reference [Unit]
Range:
0.000
16-02 -200.0 - 200.0 %
Range:
0.0%
16-03 Status Word
Range:
*
0
16-05 Main Actual Value [%]
Range:
0.00%
[0 - 9999] This parameter contains data used by the MCT10 software tool.
Function:
[0 - FFFF] View the Control word sent from the frequency converter via the
serial communication port in hex code.
Function:
*
[-999999.000 - View the present reference value applied on impulse or analog
999999.000] basis in the unit resulting from the configuration selected in par.
1-00 (Hz, Nm or RPM).
Function:
* [] View the total reference. The total reference is the sum of dig-
ital, analog, preset, bus, and freeze references, plus catch-up
and slow-down.
Function:
[0 - FFFF] View the Status word sent from the frequency converter via the
serial communication port in hex code.
Function:
* [-100.00% - View the two-byte word sent with the Status word to the bus
100.00%] Master reporting the Main Actual Value. Please refer to the Pro-
fibus Operating Instructions MG.33.CX.YY for a detailed de-
scription.
®
MG.20.O2.02 - VLT is a registered Danfoss trademark
2. Parameter Description
161
2