Danfoss VLT AQUA Programming Manual page 24

1. How to Programme
1 1.
2a. Press [Status] - [Main Menu] - [OK]
2b. Press [Menu] while power up for LCP
3.
4.
24
Disconnect from mains and wait until
the display turns off.
at the same time while power up for
LCP 102, Graphical Display
101, Numerical Display
Release the keys after 5 s.
The frequency converter is now pro-
grammed according to default set-
tings.
NB!
When you carry out manual initialisation, you also reset serial communication, RFI
filter settings (par. 14-50) and fault log settings.
Removes parameters selected in
NB!
After initialization and power cycling, the display will not show any information until
after a couple of minutes.
MG.20.O2.02 - VLT
®
VLT
This procedure initialises all except:
Operating Hours
15-00
15-03 Power-up's
Over temp's
15-04
15-05 Over volt's
Personal Menu
.
®
is a registered Danfoss trademark
AQUA Drive Programming Guide