Danfoss VLT AQUA Programming Manual page 43

®
VLT AQUA Drive Programming Guide
2.2.10. Time Zone Offset, 0-73
0-73 Time Zone Offset
Range:
*
0.00
0-74 DST/Summertime
Option:
*
[0]
[2]
0-76 DST/Summertime Start
Range:
2000-01
-01
00:00
0-77 DST/Summertime End
Range:
2000-01
-01
00:00
0-79 Clock Fault
Option:
*
[0]
[1]
0-81 Working Days
Array with 7 elements [0]-[6] displayed below parameter number in display. Press OK and
Step between elements by means of ▲ and ▼ buttons on the LCP.
[0]
*
[1]
Function:
[ -12.00 - 13.00] Sets the time zone offset to UTC, this is needed for automatic
DST adjustment.
Function:
Choose how Daylight Saving Time/Summertime should be han-
dled. For manual DST/Summertime enter the start date and end
date in par. 0-76 and 0-77.
OFF
Manual
Function:
[2000-01-01 00:00 – Sets the date and time when summertime/DST starts. The date
2099-12-31 23:59 ] is programmed in the format selected in par. 0-71.
*
Function:
[2000-01-01 00:00 – Sets the date and time when summertime/DST ends. The date
2099-12-31 23:59 ] is programmed in the format selected in par. 0-71.
*
Function:
Enables or disables the clock warning, when the clock has not
been set or has been reset due to a power-down and no backup
is installed.
Disabled
Enabled
Set for each weekday if it is a working day or a non-working
day. First element of the array is Monday. The working days are
used for Timed Actions.
No
Yes
®
MG.20.O2.02 - VLT is a registered Danfoss trademark
2. Parameter Description
43
2