Danfoss VLT AQUA Programming Manual page 133

®
VLT AQUA Drive Programming Guide
[3]
[4]
[5]
[6]
[7]
[8]
[9]
[10]
[11]
[12]
[13]
[14]
[15]
[16]
[17]
[18]
[19]
[20]
[21]
[22]
[23]
[24]
[25]
[26]
[27]
[28]
[29]
[33]
[34]
[35]
[36]
[37]
[38]
[39]
In range See parameter group 5-3* for further description.
On reference See parameter group 5-3* for further description.
Torque limit See parameter group 5-3* for further description.
Current limit See parameter group 5-3* for further description.
Out of current range See parameter group 5-3* for further description.
Below I See parameter group 5-3* for further description.
LOW
Above I See parameter group 5-3* for further description.
HIGH
Out of speed range
Below speed low See parameter group 5-3* for further description.
Above speed high See parameter group 5-3* for further description.
Out of feedb. range
Below feedb. low
Above feedb. high
Thermal warning See parameter group 5-3* for further description.
Mains out of range See parameter group 5-3* for further description.
Reversing See parameter group 5-3* for further description.
Warning See parameter group 5-3* for further description.
Alarm (trip) See parameter group 5-3* for further description.
Alarm (trip lock) See parameter group 5-3* for further description.
Comparator 0 Use the result of comparator 0 in the logic rule.
Comparator 1 Use the result of comparator 1 in the logic rule.
Comparator 2 Use the result of comparator 2 in the logic rule.
Comparator 3 Use the result of comparator 3 in the logic rule.
Logic rule 0 Use the result of logic rule 0 in the logic rule.
Logic rule 1 Use the result of logic rule 1 in the logic rule.
Logic rule 2 Use the result of logic rule 2 in the logic rule.
Logic rule 3 Use the result of logic rule 3 in the logic rule.
Digital input DI18 Use the value of DI18 in the logic rule (High = TRUE).
Digital input DI19 Use the value of DI19 in the logic rule (High = TRUE).
Digital input DI27 Use the value of DI27 in the logic rule (High = TRUE).
Digital input DI29 Use the value of DI29 in the logic rule (High = TRUE).
Digital input DI32 Use the value of DI32 in the logic rule (High = TRUE).
Digital input DI33 Use the value of DI33 in the logic rule (High = TRUE).
Start command This event is TRUE if the frequency converter is started by any
means (either via digital input, field bus or other).
®
MG.20.O2.02 - VLT is a registered Danfoss trademark
2. Parameter Description
133
2