Danfoss VLT AQUA Programming Manual page 38

2. Parameter Description
[170]
[171]
[172]
2
[173]
[180]
0-31 Custom Readout Min Value
Range:
0.00
0-32 Custom Readout Max Value
Range:
100.00
0-37 Display Text 1
Option:
0-38 Display Text 2
Option:
38
psi
lb/in 2
in WG
ft WG
Power:
HP
Function:
* [0 - par. 32] This parameter allows the choice of the min. value of the custom
defined readout (occurs at zero speed). It is only possible to
select a value different to 0 when selecting a linear unit in
tom Readout Unit
minimum value will be 0.
Function:
* [Par. 0-31 - This parameter sets the max value to be shown when the speed
999999.99 ] of the motor has reached the set value for
Limit
Function:
In this parameter it is possible to write an individual text string
for display in the LCP or to be read via serial communication. If
to be displayed permanently select Display Text 1 in par. 0-20,
0-21, 0-22, 0-23 or 0-24,
tons on the LCP to change a character. Use the ◀ and ▶ buttons
to move the cursor. When a character is highlighted by the cur-
sor, it can be changed. Use the ▲ or ▼ buttons on the LCP to
change a character. A character can be inserted by placing the
cursor between two characters and pressing ▲ or ▼.
Function:
In this parameter it is possible to write an individual text string
for display in the LCP or to be read via serial communication. If
to be displayed permanently select Display Text 2 in par. 0-20,
0-21, 0-22, 0-23 or 0-24,
tons on the LCP to change a character. Use the ◀ and ▶ buttons
to move the cursor. When a character is highlighted by the cur-
sor, this character can be changed. A character can be inserted
by placing the cursor between two characters and pressing ▲ or
▼.
MG.20.O2.02 - VLT
VLT
, par. 0-30. For Quadratic and Cubic units the
, (par.4-13/4-14).
Display Line XXX
Display Line XXX
®
is a registered Danfoss trademark
®
AQUA Drive Programming Guide
Cus-
Motor Speed High
. Use the ▲ or ▼ but-
. Use the ▲ or ▼ but-