Danfoss VLT AQUA Programming Manual page 162

2. Parameter Description
16-09 Custom Readout
Range:
0.00
2 Custom-
Readou-
tUnit
2.15.3. 16-1* Motor Status
Parameters for reading the motor status values.
16-10 Power [kW]
Range:
0.0kW
16-11 Power [hp]
Range:
0.00hp
16-12 Motor Voltage
Range:
0.0V
16-13 Motor Frequency
Range:
0.0Hz
16-14 Motor Current
Range:
0.00A
162
Function:
[-999999.99 - View the user-defined readouts as defined in par. 0-30, 0-31
999999.99 Custom- and 0-32.
ReadoutUnit]
*
Function:
*
[0.0 - 1000.0 kW] View the motor power in kW. The value shown is calculated on
the basis of the actual motor voltage and motor current. The
value is filtered, and therefore approx. 30 ms may pass from
when an input value changes to when the data read-out values
change.
Function:
* [0.00 - 1000.00 hp] View the motor power in hp. The value shown is calculated on
the basis of the actual motor voltage and motor current. The
value is filtered, and therefore approx. 30 ms may pass from
when an input value changes to when the data read-out values
change.
Function:
* [0.0 - 6000.0 V] View the motor voltage, a calculated value used for controlling
the motor.
Function:
* [0.0 - 6500.0 Hz] View the motor frequency, without resonance dampening.
Function:
* [0.00 - 0.00 A] View the motor current measured as a mean value, IRMS. The
value is filtered, and thus approx. 30 ms may pass from when
an input value changes to when the data read-out values
change.
MG.20.O2.02 - VLT
®
VLT AQUA Drive Programming Guide
®
is a registered Danfoss trademark