Danfoss VLT AQUA Programming Manual page 122

2. Parameter Description
[0]
[1]
2
[2]
[3]
[4]
[6]
[7]
[8]
[9]
[10]
[11]
[255]
9-65 Profile Number
Range:
*
0
9-70 Edit Set-up
Option:
[0]
[1]
[2]
[3]
[4]
[9]
This parameter is unique to LCP and fieldbuses. See also par. 0-11
9-71 Save Data Values
Option:
122
Read only
9.6 kbit/s
19.2 kbit/s
93.75 kbit/s
187.5 kbit/s
500 kbit/s
1500 kbit/s
3000 kbit/s
6000 kbit/s
12000 kbit/s
31.25 kbit/s
45.45 kbit/s
No baud rate found
Read only
[0 - 0]
NB!
This parameter is not visible via LCP.
Factory setup
* Setup 1
Setup 2
Setup 3
Setup 4
Active setup
MG.20.O2.02 - VLT
Function:
This parameter contains the profile identification. Byte 1 con-
tains the profile number and byte 2 the version number of the
profile.
Function:
Select the set-up to be edited.
Uses default data. This option can be used as a data source to
return the other set-ups to a known state.
Edits Set-up 1.
Edits Set-up 2.
Edits Set-up 3.
Edits Set-up 4.
Follows the active set-up selected in par. 0-10.
Function:
Parameter values changed via Profibus are not automatically
stored in non-volatile memory. Use this parameter to activate a
function that stores parameter values in the EEPROM non-vol-
®
is a registered Danfoss trademark
®
VLT AQUA Drive Programming Guide
Edit set-up
.