Danfoss VLT AQUA Programming Manual page 86

2. Parameter Description
[72]
[73]
2
[74]
[75]
[80]
[81]
[82]
[83]
[84]
[85]
[160]
[161]
[165]
[166]
[167]
[168]
86
Logic Rule 2 See par. group 13-4*. If Logic Rule 2 is evaluated as TRUE, the
output will go high. Otherwise, it will be low.
Logic Rule 3 See par. group 13-4*. If Logic Rule 3 is evaluated as TRUE, the
output will go high. Otherwise, it will be low.
Logic Rule 4 See par. group 13-4*. If Logic Rule 4 is evaluated as TRUE, the
output will go high. Otherwise, it will be low.
Logic Rule 5 See par. group 13-4*. If Logic Rule 5 is evaluated as TRUE, the
output will go high. Otherwise, it will be low.
SL Digital Output A See par. 13-52
ever the Smart Logic Action [38]
The input will go low whenever the Smart Logic Action [32] Set
dig. out. A low is executed.
SL Digital Output B See par. 13-52
ever the Smart Logic Action [39]
The input will go low whenever the Smart Logic Action [33]
dig. out. A low
SL Digital Output C See par. 13-52
ever the Smart Logic Action [40]
The input will go low whenever the Smart Logic Action [34]
dig. out. A low
SL Digital Output D See par. 13-52
ever the Smart Logic Action [41]
The input will go low whenever the Smart Logic Action [35]
dig. out. A low
SL Digital Output E See par. 13-52
ever the Smart Logic Action [42]
The input will go low whenever the Smart Logic Action [36]
dig. out. A low
SL Digital Output F See par. 13-52
ever the Smart Logic Action [43]
The input will go low whenever the Smart Logic Action [37]
dig. out. A low
No alarm Output is high when no alarm is present.
Running reverse The output is high when the frequency converter is running
counter clockwise (the logical product of the status bits 'running'
AND 'reverse').
Local reference active Output is high when par. 3-13
when par. 3-13
same time as the LCP is in Hand on mode.
Remote reference ac- Output is high when par. 3-13
Linked to hand/auto
tive
Start command active Output is high when there is an active Start command (i.e. via
digital input bus connection or [Hand on] or [Auto on], and no
Stop or Start command is active.
Drive in hand mode Output is high when the frequency converter is in Hand on mode
(as indicated by the LED light above [Hand on].
MG.20.O2.02 - VLT
®
VLT
SL Control Action
. The input will go high when-
Set dig. out. A high
SL Control Action
. The input will go high when-
Set dig. out. A high
is executed.
SL Control Action
. The input will go high when-
Set dig. out. A high
is executed.
SL Control Action
. The input will go high when-
Set dig. out. A
is executed.
SL Control Action
. The input will go high when-
Set dig. out. A high
is executed.
SL Control Action . The input will go high when-
Set dig. out. A high
is executed.
Reference Site
Reference Site Linked to hand auto
= [0]
Reference Site = Remote
[0] while the LCP is in [Auto on] mode.
®
is a registered Danfoss trademark
AQUA Drive Programming Guide
is executed.
is executed.
Set
is executed.
Set
high is executed.
Set
is executed.
Set
is executed.
Set
= [2] Local or
at the
[1] or