Main Menu - Time-Based Functions - Group - Danfoss VLT AQUA Programming Manual

2. Parameter Description

2.20. Main Menu - Time-based Functions - Group 23

2.20.1. Timed Actions, 23-0*
2
Timed Actions
Use
references for working hours / non-working hours. Up to 10 Timed Actions can be programmed
in the frequency converter. The Timed Action number is selected from the list when entering
parameter group 23-0* from the Local Control Panel. Par. 23-00 – 23-04 then refer to the selected
Timed Action number. Each Timed Action is divided into an ON time and an OFF time, in which
two different actions may be performed.
23-00 ON Time
Array [10]
00:00:0
*
0
23-01 ON Action
Array [10]
[0]
[1]
[2]
[3]
[4]
[5]
[10]
[11]
[12]
[13]
[14]
[15]
212
for actions needing to be performed on a daily or weekly basis, e.g. different
NB!
The clock (parameter group 0-7*) must be correctly programmed for Timed Actions
to function correctly.
[00:00:00 –23:59:59] Sets the ON time for the Timed Action.
*
DISABLED
No action
Select setup 1
Select setup 2
Select setup 3
Select setup 4
Select preset ref. 0
Select preset ref. 1
Select preset ref. 2
Select preset ref. 3
Select preset ref. 4
Select preset ref. 5
MG.20.O2.02 - VLT
®
VLT AQUA Drive Programming Guide
NB!
The frequency converter has no back up of the
clock function and the set date/time will reset to
default (2000-01-01 00:00) after a power down
unless a Real Time Clock module with back up is
Clock Fault
installed. In par. 0-79,
program for a Warning in case clock has not been
set properly, e.g. after a power down.
®
is a registered Danfoss trademark
, it is possible to