Danfoss VLT AQUA Programming Manual page 11

®
VLT AQUA Drive Programming Guide
1.1.6. Quick Menu Mode
The GLCP provides access to all parameters listed under the Quick Menus. The NLCP only provides
access to the Quick Setup parameters. To set parameters using the [Quick Menu] button:
Pressing [Quick Menu] the list indicates the different areas contained in the Quick menu.
Efficient Parameter Set-up for Water Ap-
plications
The parameters can easily be set up for the vast majority of the water and wastewater applications
only by using the [Quick Menu].
The optimum way to set parameters through the [Quick Menu] is by following the
below steps:
1.
2.
3.
It is recommended to do the set-up in the order listed.
Select
grammed as personal parameters. For example, a pump or equipment OEM may have pre-
programmed these to be in My Personal Menu during factory commissioning to make on site
commissioning / fine tuning simpler.. These parameters are selected in parameter 0-25
sonal Menu
Illustration 1.1: Quick menu view.
*The display showing depends on choices made in parameter 0-02 and 0-03. The default setting
of parameters 0-02 and 0-03 depends on which region of the world the frequency converter is
supplied to but can be re-programmed as required.
No Operation
If
enable start.
Coast Inverse
If
essary to enable start.
Select
•
•
Press [Quick Setup] for selecting basic motor settings, ramp times, etc.
Press [Function Setups] for setting up the required functionality of the frequency con-
verter - if not already covered by the settings in [Quick Setup].
General Settings
Choose between
My Personal Menu
to display only the parameters, which have been pre-selected and pro-
. Up to 20 different parameters can be defined in this menu.
is selected in terminal 27 no connection to +24 V on terminal 27 is necessary to
(factory default value) is selected in Terminal 27, a connection to +24V is nec-
Changes made
to get information about:
the last 10 changes. Use the up/down navigation keys to scroll between the last 10
changed parameters.
the changes made since default setting.
®
MG.20.O2.02 - VLT is a registered Danfoss trademark
Open Loop Settings Closed Loop Settings.
, and
Par. Designation
0-01 Language
1-20 Motor Power
1-22 Motor Voltage
1-23 Motor Frequency
1-24 Motor Current
1-25 Motor Nominal Speed
3-41 Ramp 1 Ramp up Time
3-42 Ramp 1 Ramp down Time [s]
4-11 Motor Speed Low Limit
4-13 Motor Speed Low High
1-29 Automatic Motor Adaption [AMA]
Table 1.1: Quick Setup parameters
1. How to Programme
My Per-
[Units]
[kW]
[V]
[Hz]
[A]
[RPM]
[s]
[RPM]
[RPM]
11
1