Address/Channel List Parameter - Keysight U2722A Programmer's Reference Manual

Address/Channel List Parameter

There are two ways to specify the U2722A/U2723A address or channel list
parameter. To specify a single channel, use the following syntax.
For example, CURR 0.02, (@1), where (@1) specifies channel 1.
To specify a single address, use the following syntax.
For example, CONF:SSI SLAV, (@1), where (@1) specifies address 1.
To specify more than one address, the following syntax must be used.
– The command CONFigure:SSI is the only U2722A/U2723A command that
NOTE
– When adding a channel list parameter to a query, you must include a space
Keysight U2722A/U2723A Programmer's Reference
(@<ch>)
(@<address>)
(@<address>[,<address>])
uses the range of address list.
character between the query indicator (?) and channel list parameter.
Otherwise error –103, "Invalid separator" will occur.
Introduction to Programming 1
17