Status:operation:enable - Keysight U2722A Programmer's Reference Manual

10 STATus Subsystem

STATus:OPERation:ENABle

Syntax
STATus:OPERation:ENABle <value>
This command and its query set and read the value of the Operation Status Enable
register. The enable register is a mask for enabling specific bits from the Operation
Event register to set the operation summary bit (OPER) of the Status Byte register.
This bit (bit 7) is the logical OR of all the Operation Event register bits that are
enabled by the Operation Status Enable register.

STATus:OPERation:ENABle?

This query the value of the Operation Status Enable register
For more information on the SCPI Status System, refer to
NOTE
system diagram"
Parameters
Item Type
NR1
<value>
For example, to enable bit 5 (decimal value = 32) and bit 6 (decimal value = 64),
the corresponding decimal value would be 96 (32 + 64).
84
on page 21.
Range of values
A decimal value which corresponds to the binary-weighted
sum of the bits in the register (refer to the table below).
Keysight U2722A/U2723A Programmer's Reference
Chapter 2, "Status
Defaul t value
Preset = 0