Status:operation[:Event] - Keysight U2722A Programmer's Reference Manual

10 STATus Subsystem

STATus:OPERation[:EVENt]?

Syntax

STATus:OPERation[:EVENt]?

This query returns the value of the Operation Status Event register. The Event
register is a read-only register, which stores (latches) all events that are passed by
the Operation NTR and/or PTR filter. Reading the Operation Status Event register
clears it.
For more information on the SCPI Status System, refer to
NOTE
system diagram"
Remarks
– The following table lists the bit definitions for the Operation Status registers.
Bit number Decimal value
0 to 1 Not Used 0
2 DTG1-tran 4
3 DTG2-tran 8
4 DTG3-tran 16
5 WTG1-tran 32
6 WTG2-tran 64
7 WTG3-tran 128
8 to 15 Not Used 0
– Once a bit is set, it remains set until cleared by reading the event register or
86
on page 21.
Definition
0 is returned.
The transient system has received a trigger signal and operation is running in channel 1.
The transient system has received a trigger signal and operation is running in channel 2.
The transient system has received a trigger signal and operation is running in channel 3.
The transient system is waiting for a trigger in channel 1.
The transient system is waiting for a trigger in channel 2.
The transient system is waiting for a trigger in channel 3.
0 is returned.
the clear status (*CLS) command.
Keysight U2722A/U2723A Programmer's Reference
Chapter 2, "Status