Status:operation:ptransition - Keysight U2722A Programmer's Reference Manual

10 STATus Subsystem

STATus:OPERation:PTRansition

Syntax
STATus:OPERation:PTRansition <value>
This register serves as a polarity filter between the Questionable Condition and
Questionable Event registers. When a bit in the Questionable PTR register is set
to 1, then a 0-to-1 transition of the corresponding bit in the Questionable
Condition register causes that bit in the Questionable Event register to be set.

STATus:OPERation:PTRansition?

These reads the value of the Questionable PTR (Positive-Transition) register.
For more information on the SCPI Status System, refer to
NOTE
system diagram"
Parameters
Item Type
NR1
<value>
For example, to enable bit 5 (decimal value = 32) and bit 6 (decimal value = 64),
the corresponding decimal value would be 96 (32 + 64).
90
on page 21.
Range of values
A decimal value which corresponds to the binary-weighted sum
of the bits in the register (refer to the table below).
Keysight U2722A/U2723A Programmer's Reference
Chapter 2, "Status
Defaul t value
Preset = 252