Status:questionable:ptransition - Keysight U2722A Programmer's Reference Manual

10 STATus Subsystem

STATus:QUEStionable:PTRansition

Syntax
STATus:QUEStionable:PTRansition <value>
This register serves as a polarity filter between the Questionable Condition and
Questionable Event registers. When a bit in the Questionable PTR register is set
to 1, then a 0-to-1 transition of the corresponding bit in the Questionable
Condition register causes that bit in the Questionable Event register to be set.

STATus:QUEStionable:PTRansition?

These command reads the value of the Questionable PTR (Positive-Transition)
register.
For more information on the SCPI Status System, refer to
NOTE
system diagram"
Parameter
Item Type
NR1
<value>
For example, to enable bit 4, the corresponding decimal value would be 16.
Remarks
– The following table lists the bit definitions for the Questionable Status
Bit number
0 to 3 Not Used
4 OT
5 to 15 Not Used
– The
100
on page 21.
Range of values
A decimal value which corresponds to the binary-weighted
sum of the bits in the register (refer to the table below).
registers.
Decimal value
0
16
0
STATus:PRESet
Definition
0 is returned.
The over-temperature protection has tripped.
0 is returned.
command will set all bits in the PTR register to 1.
Keysight U2722A/U2723A Programmer's Reference
Chapter 2, "Status
Defaul t value
Preset = 16