Procedure
Proceed as follows to mount the converter:
1. Plug the converter into the bus module so that the two domes on the rear engage in the
guide holes of the bus module.
2. Holding the converter firmly against the module rack, screw it in place with 4 screws on
the top and 4 screws on the bottom.
The upper 4 screws simultaneously fasten the bus module.
①
②
③
④
Figure 4-12
The converter is mounted.
SIMATIC ET 200pro FC-2 converter
Operating Instructions, 09/2017, FW V4.7 SP9, A5E34257324B AE
Connection module
Interface module
Frequency converter
Bus terminating module
Mounting the frequency converter
Installation
4.7 Mounting the converter
43