Replacing The Et 200Pro Fc-2 - Siemens SIMATIC ET 200pro Series Operating Instructions Manual
Low voltage converter for the distributed i/o system
Hide thumbs
Also See for SIMATIC ET 200pro Series:
- Operating instructions manual (545 pages) ,
- Quick manual (260 pages) ,
- Original instructions manual (256 pages)
Table of Contents
Advertisement
Repair
9.1 Replacing the ET 200pro FC-2
9.1
Replacing the ET 200pro FC-2
Replacing the ET 200pro FC-2
If the ET 200pro FC-2 requires to be replaced, due to a persistent fault condition, then the
procedures outline below should be performed.
Unexpected drive behaviour by unsuitable converter settings
When replacing the ET 200pro FC-2 the converter should be replaced with another
converter with the same firmware version of the converter being replaced.
If the firmware versions are different, it is possible that the converter will not respond in
exactly the same manner as the old converter. This could result in unexpected behaviour of
the replacement converter.
• If the firmware version of the replacement converter is different, then you have to
198
WARNING
recommission the converter from the default factory settings.
Operating Instructions, 09/2017, FW V4.7 SP9, A5E34257324B AE
SIMATIC ET 200pro FC-2 converter
Advertisement
Table of Contents
