Setting The Motor Standard, System Of Units And Technology Unit Using Starter - Siemens SIMATIC ET 200pro Series Operating Instructions Manual

Advanced commissioning
7.6 Selecting physical units
Unit group
Parameters involved with p0595 belong to unit group 9_1.
More information on this topic is provided in the List Manual.
Special features
You must optimize the technology controller after changing p0595 or p0596.
7.6.4 Setting the motor standard, system of units and technology unit using
STARTER
Precondition
STARTER must be in the offline mode to switch over the units.
Select the online mode or the offline mode
using the adjacent buttons.
STARTER indicates whether you change the settings online in the converter or offline in the
PC:
Procedure
Proceed as follows to select the motor standard and system of units using STARTER:
1. Select in the "Configuration" project tree.
2. Select under the "Units" tab.
3. Select the system of units.
4. Select the technological unit of the technology controller.
5. Select the motor standard.
110
Manuals for your inverter (Page 262)
/ .
Operating Instructions, 09/2017, FW V4.7 SP9, A5E34257324B AE
SIMATIC ET 200pro FC-2 converter