Area Designation
The Area Designation mode enables you to frame areas to copy or areas to blank
out in the copy. You can designate up to four areas using the edit pen on the
preview screen, or the numeric keys on the inch entry pop-up screen.
IMPORTANT
If the designated area is too small, the color original may be scanned in the Black mode,
even if the color mode is set to 'Auto-Color Select'.
NOTE
•
You can use the numeric keys to modify areas designated with the edit pen.
•
If you designate an area using the edit pen, the output image may not reflect the
designated area precisely. To designate an area precisely, enter the values using the
numeric keys.
I Framing
This setting enables you to copy only the contents of the designated area while discarding
the rest of the image. The following two designation methods are available:
•
Using the edit pen
- Use the edit pen to specify the area.
1
Points
Use multiple points
to designate the area
1
Original
Use two points to
designate the area
Designate an Area
Area
Designate an Area
Area
Copy
Area Designation
6-17
6