Transparency Interleaving - Canon imageRUNNER C3220 Copying Manual

Transparency Interleaving

This mode enables you to automatically add an interleaving sheet of paper
between each sheet of transparency that is output. The interleaf sheets protect the
copied surface of the transparencies. You can also set to copy the content of the
transparencies onto the interleaf sheets.
3
IMPORTANT
•
The Transparency Interleaving mode cannot be used with the Multi-Page Enlargement,
Finisher, Two-sided, Sample Set, Two-page Separation, Cover/Sheet Insertion, Image
Combination, Booklet, Image Repeat, Mirror Image, Area Designation, or Tab Paper
mode.
•
You cannot make more than one set of copies at a time in the Transparency Interleaving
mode.
•
Even if an optional finisher is attached, you cannot use any of the Finisher modes with
the Transparency Interleaving mode.
•
Only LTR is available for the Transparency Interleaving mode.
NOTE
•
The machine's counter does not count blank interleaf sheets as copies.
•
Regardless of Tray Designation settings, transparencies are output as follows. The Tray
Designation settings may vary depending on the optional output units that are attached
to the machine. For instructions on using Tray A, B, or C, see Chapter 4, "Customizing
Settings," in the Reference Guide.
- Tray A if no optional equipment is attached
- Tray A or C if the optional Copy Tray Unit-H1 is attached
- Tray B if the optional Finisher-M1 is attached
- Tray C if the optional Finisher-N1 or Saddle Finisher-N2 is attached
3-20

Transparency Interleaving