❑
Designate the area using the edit pen.
Mark the two opposing points with the edit pen.
If you designate a point outside the permitted area, a message appears to
inform you that the specified position is not acceptable.
NOTE
•
To clear the first point entered, press [Erase Point]. (Once an area is designated,
[Erase Point] changes to [Clear Area].)
•
To clear a designated area, press [Clear Area].
To zoom in on any area on the original, press the ratio drop-down list © select an
•
enlargement ratio © press [ ], [ ], [M], or [L] to specify the area to display.
•
To check the designated area, press [Preview].
•
To modify a designated area that was specified using the edit pen, press [Area Fine
Adj.] © [Point select] until the screen displays the desired point that you want to
modify © press [
], [
[Preview] to check the modified area.
❑
Press [OK].
The display returns to the Image Repeat screen.
] to move the point © press [Done] ©
], [
], or [
Using Image Creation Modes
Ratio
6-11
6