Job Build
This mode enables you to scan originals that are too many to be placed at once, by
dividing them into multiple batches. You can use both the feeder and the platen
glass for scanning. The originals are printed as one document after all of the
batches have been scanned.
5
IMPORTANT
•
The Job Build mode cannot be used with the Multi-Page Enlargement mode.
•
You cannot change the copy settings while the machine is scanning originals in the Job
Build mode. You need to set the necessary copy settings beforehand, according to the
type of originals and the desired result.
•
You can change or specify the following settings before scanning the next batch of
originals (i.e., between batches): the number of copies, Two-sided Original mode, original
type, copy exposure, color mode, and copy ratio. However, if you specify the Image
Combination mode with the Job Build mode, you cannot change the copy exposure,
original type, color mode, and copy ratio.
•
If you place your originals into the feeder, remove the originals from the original output
area when the scanning of each batch is complete.
5-4
Job Build
Originals
Copies