Replacing The Fan Filter - SATO S84ex Operator's Manual

8
Insert the gear end of the new media
feed roller  fully into the printer's
center frame.
9
Place the bearing  back to the chassis
and the shaft of the media feed roller.
10
Rotate the bearing clamp  onto the
bearing  and attach it with the screw
.
8.7.5

Replacing the Fan Filter

The fan filter prevents atmospheric debris from being drawn into the printer.
1
Peel off the old fan filter  from the rear
of the printer.
2
Clean the printer to remove any
adhesive residue on the surface.
Note
You can purchase a cleaning kit from a SATO reseller
or technical service center.
3
Remove the backing paper from the new
fan filter  and paste the fan filter 
over the fan exhaust holes.
6
4
S84-ex/S86-ex Operator Manual
8 Appendix
7
5
1
325