Removing The Neutral Position Sensor; Removal/Installation Of The Complete Clutch - Husqvarna TR 650 TERRA 2013 Workshop Manual

TR 650 TERRA 2013 - TR 650 STRADA 2013
1
3
1
2
7
8
Z
Z
8
10
GENERAL ENGINE PROCEDURES

REMOVING THE NEUTRAL POSITION SENSOR

- Remove the screw (2).
- Remove the connection cable.
- Unscrew the sensor (1) and replace it.
- Screw on a new sensor with Loctite 243.
2
H11548

REMOVAL/INSTALLATION OF THE COMPLETE CLUTCH

Removal:
- Remove the gearbox lever, the clutch cover and secure the engine at the top
dead centre, as described in the relevant paragraphs.
- Loosen the screws (1) proceeding with diametrically opposite operations,
then remove them with the washers (2) and the springs (3).
- Remove the pressure plate (4).
4
H11550
- Remove the lined plates (5) and the steel plates (6).
6
- Remove the Belleville washer (7) and coupling washer (8).
5
4
- Insert the special tool (A) on the hub (9) to block rotation.
- Lift the safety tab of the washer (11).
7
- Remove the nut (10) with the washer (11).
- Remove the hub (9) and the tool (A).
H11551
A
9
9
H11552
F1.13
10
11
H11553
Workshop Manual Ed.09-2012