Husqvarna TR 650 TERRA 2013 Workshop Manual page 141

CRANKCASE DISASSEMBLY
TR 650 TERRA 2013 - TR 650 STRADA 2013
6
6a
Z
- Check the wear of the crankshaft in correspondence of the "Z" contact area
of the bushings: wear limit ø 45.96 mm (1.81 in.).
Replace the crankshaft and bearings if this value is exceeded.
Bearings disassembly:
- Use a suitable tool to remove the bearings (6) and (7) from the left and right
side casings, heat the two semi-casings if needed.
Bearings installation:
If bearings are installed incorrectly, lubrication may be insufficient
with consequential seizure.
Do not invert the bearings: the bearings with the inner groove should
be mounted on the right half, the smooth bearings are mounted on
the left crankcase half.
- Place the bearings (6a) and (7a) in the lower part taking care to align the
hole in the bushing with the one present in the crankcase halves.
- Use an appropriate tool to install, heat the two crankcase halves if needed.
- Lubricate the bearings with temperature resistant oil.
Z
F3.9
7a
H11615
Workshop Manual Ed.09-2012
7