1
3
3
3
Workshop Manual Ed.09-2012
ENGINE SETTINGS AND ADJUSTMENTS
TR 650 TERRA 2013 - TR 650 STRADA 2013
TIMING CHECK
-
Remove the coil / spark plug cap, head cover, spark plugs and chain tensioner
and the head cover as described in chapter "F1".
-
Remove the screw (1) with the sealing ring.
-
Remove the plug (2).
H11488
2
H11500
-
Check the position of the camshaft gears.
-
The marks (dashes) (3) located on the camshaft gears must be coplanar with
the sealing surface.
-
Make sure the notch on the crankshaft is visible through the hole (marks (3)
coplanar to the surface and notch (4) visible indicate a correct timing).
-
If the notch cannot be seen through the hole, carefully turn the engine until it
can be seen through the hole, then fully tighten down the retaining screw (5)
manually, blocking the engine at TDC; it must perfectly engage in the notch
3
of the crankshaft.
H11501
4
H11502
If the marks on the camshaft gears are not opposed and parallel to
the sealing surface, a collision between pistons and valves is pos-
sible.
F.8
5
H11503