Removing The Rear Wheel (Procedure Valid For All Models) - Husqvarna TR 650 TERRA 2013 Workshop Manual

1
2
4
A
Workshop Manual Ed. 09-2012
CHASSIS AND WHEELS
TR 650 TERRA 2013 - TR 650 STRADA 2013

Removing the rear wheel (procedure valid for all models)

Set a stand or a block under the engine and see that the rear wheel is lifted
from the ground.
Unscrew the nut (1) of the wheel axle (3) and extract it. It is not necessary
to loosen the chain tensioners (2); in this way, the chain tension will remain
2
unchanged after reassembly. Remove the chain (4) and remove the full wheel
paying attention to the spacers on the sides of the hub. For reassembly follow the
removal procedure in the reverse order by inserting the brake disc in the calliper.
Refit the chain tensioner sliders (5) correctly so that the head of the axle (3) and
the washer (6) slot into the corresponding slider housings.
H11749
3
Tightening of rear wheel axle nut (1): 100 Nm - 10 kgm - 73.75 ft/lb.
H11750
H11738
5
3
H11739
The flat part (A) of the chain tensioner sliders must face the chain
tensioner screw.
Check the cush drive dampers for wear (7); if only one of the ap-
pears to be damaged, all of them must be replaced.
Do not operate the rear brake pedal when the wheel has been re-
moved; this causes the calliper pistons to move outwards.
After removal, lay down the wheel with brake disc on top.
After reassembly, depress the brake pedal until the pads are against
the brake disc.
5
A
6
Y.12
1
H11740
7
H11741