TR 650 TERRA 2013 - TR 650 STRADA 2013
1
2
H11764
3
1
GENERAL ENGINE PROCEDURES
Mounting the ignition cover
- Clean the sealing faces and fit a new gasket.
-
Install the cover (2), being careful with the washer (3) (arrow) and bushing
(4).
-
Install the screws (1) of the engine casing cover, right side, tightening to
1
torque in a cross pattern.
1
4
H11758
Replacement of the gearbox output shaft oil seal
-
Remove the sprocket chain as described in the relevant paragraph.
-
Use an appropriate tool to remove the oil seal (1) paying attention to avoid
damaging the seat.
-
Lubricate the new oil seal lip.
-
Cover the shaft toothing (2) with an appropriate tool or adhesive tape, suc-
cessively mount the new oil seal (1) using an appropriate tool.
- Refit the sprocket chain as described in the relevant paragraph.
H11533
2
1
H11534
F1.9
Workshop Manual Ed.09-2012