Husqvarna TR 650 TERRA 2013 Workshop Manual page 116

16
15
14
16
15a
15
14
9
Workshop Manual Ed.09-2012
GENERAL ENGINE PROCEDURES
TR 650 TERRA 2013 - TR 650 STRADA 2013
- Remove the washer (12) and the "OR" gasket (13).
- Disassemble the clutch housing (14), paying attention to the needle roller
bearings (15) and to the washer (16).
12
13
H11554
Installation:
- Lubricate the needle roller bearings (15) with engine oil.
- Insert both needle roller bearings (15) with the washer (16) into the clutch
housing (14) making sure that the bearing (15a) is positioned towards the
engine.
- Fit the clutch housing (14) all the way down, paying attention to the oil pump
gears.
- Fit the OR gasket (13) onto the gearbox shaft.
- Mount the broached washer (12) onto the shaft and push into its seat.
12
13
H11555
- Clean the tapered teeth on the primary shaft and on the clutch hub (9) and
lubricate them.
S
- Insert the special tool (A) on the hub (9) to block rotation.
- Fit the corrugated washer (11) and nut (10) with the bevelled edge "S" facing
10
outwards.
- Tighten nut to torque (10), bend the safety tab on the washer (11) (use Loctite
243).
- Remove the special tool (A).
11
H11556
A
14
9
H11651
The clutch shaft oil nozzle shall not be dirtied with threadlocker.
F1.14