Checking Brake Pads For Wear / Replacing The Pads - Husqvarna TR 650 TERRA 2013 Workshop Manual

A= 1 mm (0,039 in.)
A= 1 mm (0,039 in.)
Workshop Manual Ed. 09-2012
TR 650 TERRA 2013 - TR 650 STRADA 2013
Checking brake pads for wear / replacing the pads
Check brake pad wear.
Service limit "A"
- 1 mm - (0.039 in.) (front and rear pads)
If said limit has been exceeded, or if even only one of the wear indicators is no
longer visible, replace the pair of pads (in any case, the replacement is neces-
sary when the wear indicators are no longer visible).
Be careful that no brake fluid or any oil gets on brake pads or discs. Clean off
with alcohol any fluid or oil that inadvertently gets on the pads or disc.
Replace the pads with new ones if they cannot be cleaned satisfactorily.
DISASSEMBLY OF THE REAR PADS
- Remove the safety clip (1).
H11868
- Slide out pin (2).
- Remove the pads (3) making sure not to damage the pre-load clip inside the
calliper.
ASSEMBLY OF THE REAR PADS
- Install new brake pads.
- Reassemble the pin (2) making sure not to damage the pre-load clip inside
1
the calliper and the safety clip (1).
Acting as described above, after replacing the pads it is not necessary to bleed
the system, just act the control lever several time until the pistons get in the
normal position.
H11870
2
H11871
BRAKES
Do not use the brake pedal while removing the pads.
L.14
3
H11872