Husqvarna TR 650 TERRA 2013 Workshop Manual page 139

TR 650 TERRA 2013 - TR 650 STRADA 2013
3
4
1
2
5
7
9
11
13
12
11
11
15
CRANKCASE DISASSEMBLY
Assembly:
- Check that the washers (1) are installed correctly (also see the relevant
paragraph on checking the axial clearance).
- Clean the sealing faces and fit a new gasket (2).
- Check that the crankshaft (3) and countershaft (4) are timed correctly (see
relative paragraph).
1
H11609
- Check that the oil seal valve (5) is installed properly.
- Check that the pins (6) of the gearbox forks, the drum (7), the ratchet (8),
6
the lever (9) and the spring (10) are installed properly.
The bearings may be damaged if the crankcase is not disassembled
and assembled vertically.
Do not rock the engine crankcase during disassembly and assembly.
8
10
H11610
- Mount the left-side crankcase onto the left side casing.
- Tighten the screws (11 and 12) to torque:
Screws 11= 45 mm (1.77 in.) length.
Screws 12= 75 mm (2.95 in.) length.
11
- Clean the threading and install the neutral switch (13).
- Screw to torque with Loctite 243.
H11611
- Check that the O-ring of the oil filter cover is not damaged, replace if neces-
sary.
- Insert the oil filter and install the cover (14) with the screws (15).
14
- Refit all the previously removed components as described in the relevant
paragraphs.
15
H11612
F3.7
Workshop Manual Ed.09-2012