Crankshaft Gear Removal; Gear Installation; Replacement Of The Countershaft Bearings - Husqvarna TR 650 TERRA 2013 Workshop Manual

CRANKCASE DISASSEMBLY
TR 650 TERRA 2013 - TR 650 STRADA 2013
H11624
1
2
H11625
H11626

Crankshaft gear removal

- Place the crankshaft in a vice with protection clamps.
- Use a puller to extract the gear.

Gear installation

- Heat the gear to approx. 140°C.
- Fit a pin (1) into the gear (2) and mount onto the crankshaft until it stops by
using a suitable tool, centring the pin (1) with the hole in the crankshaft.
When installed, check that the pin (1) does not protrude from the
gear.

Replacement of the countershaft bearings

- Remove the countershaft as described in the relevant paragraph.
Removal:
- Remove the oil seal by extracting it from the outside section of the crankcase.
- Heat the left crankcase half to 100°C.
- Use a puller to remove the bearing towards the internal part of the crankcase.
- Disassembly the right bearing in the same way.
F3.13
Workshop Manual Ed.09-2012