Filling; Coolant Level Check - Husqvarna TR 650 TERRA 2013 Workshop Manual

TR 650 TERRA 2013 - TR 650 STRADA 2013
1
2
MAX
MIN
2
SETTINGS AND ADJUSTMENTS

Filling

- Remove the cap (1) with the dipstick.
- Pour 1.5 litres of oil into the chassis tank.
- Run the engine for 30 seconds and then switch it off.
- Pour another 0.5 litres of oil into the chassis tank.
- Check the oil level as described in the relevant paragraph.
Check the condition of the gasket (2) of the cap (1) with the dipstick
and if it is damaged, replace it.
For the type of oil to use, refer to the "Technical data"paragraph.
H11743

Coolant level check

When the engine is cold, check that the level of the coolant is between the MIN
and MAX marks on the expansion tank (1) on the left-hand side of the motorcycle.
If topping up is necessary, do the following:
Do not remove the radiator cap (2) since all the liquid in the expan-
3
sion tank (1) will flow out.
- Remove the cap (3) and add the fluid needed to restore the level to the ex-
pansion tank (1).
1
(for the type of liquid to use, see the section "Technical data").
Difficulties may arise in eliminating coolant from painted surfaces.
If this occurs, wash off with water.
Never exceed max. level.
H11689
H11690
D.11
Workshop Manual Ed. 09-2012