Removing The Rear Brake Calliper - Husqvarna TR 650 TERRA 2013 Workshop Manual

TR 650 TERRA 2013 - TR 650 STRADA 2013
2
1
3
5
6
BRAKES

Removing the rear brake calliper

- Loosen the screw (1) and remove the cable ring (2).
- Cut the clamps that fasten the system.
- Loosen the screw (3) and remove the speed sensor (4).
- Undo the threaded bolt (5) and remove the brake calliper (6), collecting any
fluid remaining in the line.
During reassembly, refit the rear brake lines in exactly the same
positions as before, replacing all the seal washers and fastening
with the relative clamps as indicated in the paragraph "Replacing a
brake line", and with the relative hose guide, then fill the reservoir
with brake fluid and bleed the system as described in the relative
paragraph.
H11882
4
H11867
L.13
Workshop Manual Ed. 09-2012