Chain Sprocket Removal/Installation; Starter Motor Removal/Installation - Husqvarna TR 650 TERRA 2013 Workshop Manual

4
3
2
4
3
5
Workshop Manual Ed.09-2012
GENERAL ENGINE PROCEDURES
TR 650 TERRA 2013 - TR 650 STRADA 2013

CHAIN SPROCKET REMOVAL/INSTALLATION

Removal:
- Remove the screw (1).
- Remove the bushing (2) and the tapered washer (3).
3
- Remove the sprocket (4), using a puller if necessary, being careful not to ruin
2
the shaft threading.
1
H11656
2
Installation:
- Clean and lubricate the teeth on the main shaft and on the sprocket with
1
"KLUEBER 46 MR 401" grease.
- Mate the sprocket (4) with the shaft and make sure to keep the side with the
"EXT" marking facing outwards.
- Insert the tapered washer (3) so that the larger diameter rests on the sprocket
and that the taper side of the bushing (2) faces the washer.
- Apply a thin layer of Loctite 243 on the retaining screw (1).
- Tighten the screw (1) on the shaft to torque, being careful to insert the taper
side of the bushing in the hole of the tapered washer.
H11545

STARTER MOTOR REMOVAL/INSTALLATION

Removal:
- Remove the screws (1).
- Extract the starter motor (2), paying attention to the sealing ring.
1
H11546
Installation:
- Check the sealing ring (3) for damage and replace it if necessary.
- Clean and lubricate the ring (3), then place it on the starter motor.
- Lubricate the centring tang (4) and the teeth (5).
- Fit the starter motor (2) on the crankcase and fix it with the screws (1), tight-
ening them to torque.
H11547
F1.12