TR 650 TERRA 2013 - TR 650 STRADA 2013
9
2
1
REAR SUSPENSION
- Reassemble the swinging arm and insert the pin (9) for approx. half its length.
- Using a screwdriver, turn the ring nut (11) and bring it into contact with the
swinging arm, then completely insert the pin (9) and tighten the nut with the
relative washer to torque from the right side.
11
- Reassembly everything proceeding in reverse order.
H111022
Servicing the swinging arm shaft
Check shaft taper using a dial gauge. Place the shaft on two identical reference
blocks. Turn the shaft and move the dial gauge horizontally to determine the
amount of distortion.
Service limit: 0.30 mm.
Replacement of the chain slider
Remove the swinging arm as described in the relevant paragraph.
The screw (2) must be loosened to replace the chain slider (1).
H111024
The chassis contains a seat for housing the swinging arm pin head;
position the swinging arm pin with the milled parts of the head in a
vertical position so they are correctly inserted in the seat.
J.11
Workshop Manual Ed. 09-2012