2-13-6.Factory Default Setting; 2-13-7.Setting With Intelligent Tap; 2-13-8.Setting With Sd Manager - Omron F3SG-SRB Series User Manual

 Dynamic muting allowable beam
The dynamic muting allowable beam allows the muting zone measured by the Zone Measurement to
be expanded by the number of additional beam(s) specified as allowable beam.
 Timing chart
Muting Input A
Muting Input B
Enabled
MUTING state
Disabled
Unblocked
Beam state
Blocked
Zone Measurement
2-13-6. Factory Default Setting
The muting mode is set to Standard Muting Mode and the Dynamic Muting to Disable.
2-13-7. Setting with Intelligent Tap
If the Pre-Reset function is enabled by the DIP Switch, the Muting function is disabled.
Otherwise the Muting function is always being enabled.
Refer to Chapter 3 Setting with Intelligent Tap for more information on setting this function by the Intelligent Tap.
2-13-8. Setting with SD Manager 3
The user can make changes to the settings of this function by the SD Manager 3.
Function
Muting function *
Muting mode
Setting by
Statistics data recording
*Setting parameters of the following functions is saved according to the states where the Muting function is enabled and disabled
with the SD Manager 3, respectively. After changing the Muting function from Enable to Disable or from Disable to Enable, also
check the settings of these functions again.
Affected functions: External Device Monitoring (EDM), Start Interlock, Restart Interlock, Auxiliary Output
Refer to 2-26-6. Muting Statistics Information for more information.
ON
OFF
ON
OFF
All Zone
ON
OFF
Tdyn (3 s)
Initial value
Enable
Standard muting mode
Manual
Enable
System Operation and Functions
Partial Zone
Tdyn: Measurement time
Configurable value or numerical range
Enable/Disable
Standard Muting (Installation Example1) /
Standard Muting (Installation Example2) Exit-
only muting mode/Position detection muting
mode
Manual/Teach-in
Enable/Disable
E
F3SG-SR
83
User's Manual