Omron F3SG-SRB Series User Manual page 231

For more information on the Fixed Blanking, refer to 2-15. Fixed Blanking.
If using this function together with other functions, make settings taking the condition of adjacent zones into account.
For more information on zone adjacency conditions, refer to 2-19. Setting Zone Adjacency Conditions.
When changing the settings is complete, confirm the settings and write the configuration to the F3SG-SR.
To enable the written configuration, refer to 4-2-7-3. Writing Configuration into Intelligent Tap.
When connecting the Intelligent Tap to a F3SG-SR and trying to return the F3SG-SR to [Detecting], follow step 4 of
4-1-3-2. Connection Procedure When Using USB Connector to restart the F3SG-SR and Intelligent Tap, or click the
[Monitor] button.
 Fixed Blanking Setup Procedure (Setting by Manual)
1.
Select a Fixed Blanking zone, and enable the function (No. 1).
2.
Set up the zone.
Select [Manual] in [Setting by]. (No. 2)
Set up the bottom and top beam numbers. (No. 3)
Click the [Execute] button in [Confirm zone] to determine the Fixed Blanking zone between the bottom
and top beams configured above. (No.4)
3.
Select a Fixed Blanking Monitoring function. (No. 5)
4.
Set up the number of allowable beams. (No. 5)
The allowable beams are configurable inside the Fixed Blanking zone. The set allowable beams will be
indicated in the chart as shown below.
In this example, one upper and two lower beams are set as allowable beams.
The table below describes the number of allowable beams configurable for a Fixed Blanking zone.
Number of allowable beams available for fixed blanking beams
Number of fixed blanking beams
1
2
3
4
n
5.
Click the [Write configuration] button. On the settings list which will appear, confirm that the changed
settings are correct, and click the [OK] button.
Maximum number of allowable beams
Setting not possible
1
2
3
n-1
Setting with SD Manager 3
F3SG-SR
User's Manual
E
203