Setting Initialization - Omron F3SG-SRB Series User Manual

Setting with SD Manager 3

4-3-6. Setting Initialization

This function is usable to bring the settings of each function back to the factory default settings.
Log in at the administrator level and click the icon below on the top page.
The setting screen below is displayed.
In order to execute setting initialization, click [Reset to factory default settings].
 In a cascade connection
Select the channel of the F3SF-SR sensor you wish to bring back to the factory default settings using
the [Target Sensor] button
factory default settings].
To bring all the cascaded channels back to the factory default settings, execute setting initialization for
each channel.
 With F3SG-SR connected, updating the backup settings of F3SG-SR saved in
the Intelligent Tap to the factory default settings
Initialize the settings of all the initialization target channels according to the procedure above. Then,
click the [Write] button
Unless clicking the [Write] button
this state, if restarting the F3SG-SR with the Position 1 of the DIP Switch set at ON (Lock), the F3SG-SR is restored by
the settings before initialization.
Even after the settings are returned to the factory default settings, the password which has already been changed is not
returned to initial password "0000." For the password, refer to 4-2-6. Password Protection.
F3SG-SR
220
User's Manual
in the top right corner of the screen, and click [Reset to
.
, the backup settings of F3SG-SR saved in the Intelligent Tap are not updated. In