Omron F3SG-SRB Series User Manual page 191

(1)
Power
supply
IT
IO-Link
(3)
Power
supply
IT
IO-Link
(5)
Power
supply
Power
supply
IT BT
IO-Link
PC
(7)
PC
IT
For the patterns (1) and (4), turn the power on and start the SD Manager 3 on the PC.
For the pattern (7), the power is supplied from the PC to the Intelligent Tap.
When connecting the emitter and receiver with the Intelligent Tap as shown in the above patterns (2) to
(4), it is possible to make settings to the emitter and receiver and perform IO-Link communication,
Backup and Restoration.
If the emitter is not connected with the Intelligent Tap like patterns (5) to (7) above, there are the
following restrictions.
• As synchronization method, only the optical synchronization is usable.
• It is unable to configure the following function using the DIP Switch on the Intelligent Tap.
Operating range selection
• It is unable to configure the following functions using SD Manager 3.
External test, operating range selection, lamp, area beam indicator (ABI), and vibration detection
• It is unable to monitor the emitter using the configuration tools.
• The backup and restoration functions of the emitter are not usable.
• The information of the emitter cannot be obtained via IO-Link.
Before connecting with each device, confirm that the power of the F3SG-SR and Intelligent Tap is
OFF. After connection is completed, turn ON the power and start up the F3SG-SR and Intelligent Tap.
(2)
Power
Receiver
supply
Emitter IO-Link
PC
(4)
Power
Receiver
supply
Emitter IO-Link
(6)
Power
Emitter
supply
Receiver IO-Link
Setting with SD Manager 3
IT BT
PC
Power
supply
IT
Power
supply
IT
IT: Intelligent Tap
BT: Bluetooth ® communication unit
IO-Link: IO-Link Master
Receiver
Emitter
Emitter
Receiver
PC
Emitter
Receiver
E
F3SG-SR
163
User's Manual