Omron F3SG-SRB Series User Manual page 313

2.
Slide the Top/Bottom Bracket (1) in the grooves of the sensor housing. Adjust the Top/Bottom Bracket
to the mounting position of the wall surface. Make sure to contact the whole body of the Top/Bottom
Bracket (1) with the groove of the yellow area of the housing. Securely tighten the Mounting Screws to
fix the Top/Bottom Bracket to the housing of the sensor. The recommended torque to tighten the
Mounting Screws of the Top/Bottom Bracket is 3.0 N•m. (Fig. 2)
<Backside mounting>
Mounting Screw
Securely tighten
Tightening screws with a torque that considerably exceeds the recommended torque may cause failure.
3.
Securely tighten screws to fix the Adjustable Side-Mount Bracket to the mounting position of the wall
surface. When using more than one Adjustable Side-Mount Brackets, align them in the same line using
the sides of the brackets that do not face the wall, before attaching the brackets to the sensor. (Fig. 3)
<Backside mounting>
M5/M6
Screws to mount the brackets to the wall are not included.
Slide into the backside
of the housing
Fig. 2
<Side mounting>
Fig. 3
Wiring and Installation
<Side mounting>
Slide into the backside
of the housing
Mounting Screw
Securely tighten
Align in the
same line
M5/M6
E
F3SG-SR
285
User's Manual