Programming/Erasing In User Program Mode; Figure 7.2 Programming/Erasing Flowchart Example In User Program Mode; Table 7.3 System Clock Frequencies For Which Automatic Adjustment Of Lsi Bit Rate Is - Renesas H8/36912 Series User Manual

Table 7.3 System Clock Frequencies for which Automatic Adjustment of LSI Bit Rate is

Possible
Host Bit Rate
9,600 bps
4,800 bps
2,400 bps
7.3.2

Programming/Erasing in User Program Mode

On-board programming/erasing of an individual flash memory block can also be performed in user
program mode by branching to a user program/erase control program. The user must set branching
conditions and provide on-board means of supplying programming data. The flash memory must
contain the user program/erase control program or a program that provides the user program/erase
control program from external memory. As the flash memory itself cannot be read during
programming/erasing, transfer the user program/erase control program to on-chip RAM, as in boot
mode. Figure 7.2 shows a sample procedure for programming/erasing in user program mode.
Prepare a user program/erase control program in accordance with the description in section 7.4,
Flash Memory Programming/Erasing.

Figure 7.2 Programming/Erasing Flowchart Example in User Program Mode

Rev. 1.00, 11/03, page 102 of 376
Downloaded from Elcodis.com electronic components distributor
System Clock Frequency Range of LSI
8 to 10 MHz
4 to 10 MHz
2 to 10 MHz
Reset-start
Program/erase?
Yes
Transfer user program/erase control
program to RAM
Branch to user program/erase control
program in RAM
Execute user program/erase control
program (flash memory rewrite)
Branch to flash memory application
program
No
Branch to flash memory application
program