Table of Contents
Advertisement
Vigilon Compact Voice Alarm Panel -
(legacy product)
The following procedures assume the Control panel is installed with cables terminated at the
backbox.
¨
Open the Outer door of the enclosure using the door key supplied and then open the
inner door.
¨
Remove the protective cover fitted over the printed circuit boards located inside the
backbox.
¨
Earth Lead
Ensure the earth lead located at the top right of the backbox is connected to the spade
connector on the inner door.
¨
DAC ribbon cable
Connect the 40-way ribbon cable from the DKC to the socket marked KEYBOARD
on the left edge of the Master Control Board (MCB). Secure the ribbon cable to the
side of the enclosure using the cable clamp provided.
¨
ACC DAC ribbon cable
Route the 14-way ribbon cable from the backbox on to the inner door and connect it
to the left unoccupied socket on the ACC DKC. Secure the ribbon cable to the inner
door using the cable clamp provided.
¨
Emergency microphone cable
Connect the Emergency microphone cable to the socket P11 labelled 'microphone' on
the bottom edge of the ACC board. Secure the microphone lead to the 'P' clip on the
backbox.
4188-856_issue 7_07/15_Generic Vigilon (Compact + VA) Comms.
Vigilon 4/6 loops & Compact (VA) panels & network nodes
Connect the 40-way ribbon to the socket labelled
KEYBOARD on MCB and secure cable to the side
of the enclosure.
Fit the earth lead to the inner door
ACC DKC
WARNING
REMOVAL OF COVER
EXPOSES HIGH VOLTAGE
Connect the 14-way
Secure 14-way ribbon to Inner door
ribbon to socket
using cable clamps supplied.
ACC DKC.
Mains terminal block
with fuse
P Clip for
mains cable
MCB
ACC
PSU
Connect microphone cable
to socket P11 labelled
'microphone' on the ACC
and secure cable to the P clip.
45
Advertisement
Table of Contents
