Vigilon 4/6 Loop Panels; Second Fix Parts; Remove The Protective Covers - Honeywell Vigilon 4 loop Generic Commissioning Instructions

Vigilon 4/6 loop Panels

These procedures assume the respective 1st fix assembly of the Vigilon 4 loop (VIG1-24) / 6 loop
(VIG1-72) panel is already installed. The 1st fix backbox assembly may be surface or flush
mounted.
¨
The second fix parts must now be installed before powering up the control panel.
Cables of external circuits
Earth to
inner door
Hinge
points for
inner and
outer doors
Transparent
cover over
backplane
Printer 0V
Hinge
points for
inner and
outer doors
Card guides
4188-856_issue 7_07/15_Generic Vigilon (Compact + VA) Comms.

Second fix parts

¨
Cardboard cover
over PSU
Mains cable

Remove the protective covers

¨
¨
PSU
Vigilon 4/6 loops & Compact (VA) panels & network nodes
Check that you have the second fix parts, which are supplied with the panel:
Parts
Inner door assembly
Battery Pack (2 x 12V 21Ah)
Battery box
Outer door assembly
Main Control Card
Loop card
Spares pack (see installation
manual for pack content)
Remove the cardboard protection cover fitted over the PSU. The cover is held in by a
retaining clip.
Remove the transparent protection cover fitted over the backplane held together by an
elastic band.
EN Vigilon 4 loop EN Vigilon 6 loop
Control panel Control panel
(VIG1-24) (VIG1-72)
1 1
1 2
1
1 1
1 1
1 1
(Option of (option of
up to 4 maximum) up to 6 maximum)
1pack 1pack
23