S-Quad Sensor with VAD - STATES VAD (current range of devices)
The STATE in which an S-Quad sensor operate can be changed from the default factory set STATE to another STATE during commissioning using the Commissioning tool. The environment in which
an S-Quad device is installed will determine what STATE is used. # - Factory Default STATE ~ EN54 : Part 7 :2000 * EN54 : Part 5 :2002
&
The S-Quad with VAD devices are compatible with control panel software (MCC/MCB equal to or greater than V4.52 and LPC equal to or greater than V4.48).
# - factory default settings
Device
Dual Optical & Heat sensor variant -
(With VAD)
(With Speech)
(With VAD & Speech)
(With Sounder)
Dual Optical, Heat & CO sensor variant-
(With Speech & VAD)
Optical & Heat sensor variant -
(With Sounder)
Heat sensor variant -
(With Speech VAD)
(With Sounder)
Optical sensor
All of the above S-Quad range of devices meet EN54-17:2005 Short circuit isolation plus EN54-18:2005 Input/Output devices for use on the transmission path of fire detection and alarm systems.