Honeywell Vigilon 4 loop Generic Commissioning Instructions page 122

Commissioning instructions
Message associated with..
Power supply
DC too high / DC too
low
MCC / MCB
Delay block setup
(main control card/board)
Delay blocks Cleared MCC / MCB
(main control card/board)
LPC
Detection Zone
Disabled/Enabled at
(loop processor card)
card x
Detector on interface Device
unit number x on
loop y channel z
Device
Device Address
changed from x
number y on loop z
Radio (Plexus) Device
Device Battery Fault
Device batteries need Radio (Plexus) Device
replacing
Radio (Plexus) Device
Device battery
discharged
Device battery fault Device
/restored
122
meaning..
The DC supply is:
Too high if greater than 164 (32V)
Too low if less than 102 (20V)
A Delay Block has been configured.
-
The detection zone has been enabled or disabled
automatically or manually.
Conventional detector connected to an input of a mains
powered interface input has triggered. Value of the
input is equal to or less than 10V.
Device SAFE address has changed.
Radio (Plexus) device has a battery failure
The batteries inside a Radio (Plexus) device needs to
be replaced
The batteries inside a Radio (Plexus) device are
nearing end of life.
The battery has failed the load test at the device, for a
mains powered interface the value is equal to or less
than normal - 2V.
..possible action
Check the mains supply and battery wiring.
-
-
If necessary, manually enable/disable the
detection zone using the [control] menu.
-
If necessary rectify the device SAFE address.
Check the batteries at the Radio (Plexus) device
using the Battery Condition Indicator tool and
replace the batteries if necessary
Replace the batteries in the Radio (Plexus)
device
Replace the batteries in the Radio (Plexus)
device
Check and replace the battery if necessary.
4188-856_issue 7_07/15_Generic Vigilon (Compact + VA) Comms.