Table of Contents
Advertisement
Message
associated with..
Network Card
New domain address n
at card x
NMI's missed at
LPC
card x
(loop processor card)
Any Card
No periodic
interrupts at card x
LPC
No response number x
loop y
(loop processor card)
No room on NVM card
NVM
(non volatile memory) on
backplane or MCB
Network Card
Node double allocated
at card x
Node found at card x
Network Card
Network Card
Node lost/restored at
card x
Any Card
Not enough RAM at
card x
LPC
Nothing found at
card x
(loop processor card)
NVM
NVM initialised
(non volatile memory)on
backplane or MCB
NVM
NVM is not write
(non volatile memory)on
protected
backplane or MCB
4188-856_issue 7_07/15_Generic Vigilon (Compact + VA) Comms.
Vigilon 4/6 loops & Compact (VA) panels & network nodes
meaning..
The new address set been read at the particular card.
Software error.
Problem with software, the watchdog will operate the
MCC / MCB (main control card/board).
There is no communication with repeat or mimic panel
software.
User attempts to backup or save to an NVM that does
not have enough free space
Two network cards have same address.
Another panel on the network acknowledged.
There have been 15 missing replies from another panel.
Not enough memory.
No devices found on End 1 or End 2.
Memory available verified.
Read and write is possible to the memory card.
..possible action
-
Software errors will activate a system reset.
Ignore single occurrence. Record the event in
the log book.
Software error will activate a system reset.
Ignore single occurrence. Record event in the
log book.
Power-up the repeat or mimic panel.
If there is no memory left then the card 14
located on the Backplane or on
MCB (Card 0) needs to be initialised
Keep address unique.
-
Check the wiring or check and reset the panel
Network card to restore.
Reset the card and ignore single occurrence. If
necessary replace the card or add RAM, where
applicable.
Check wiring of loop circuit.
-
Enable protect if required using the [set up]
menu.
131
Advertisement
Table of Contents
