Intended Use - Festo CPX-CM-HPP Electronic Manual

Contents and general instructions

Intended use

Festo P.BE−CPX−CM−HPP−E N en 0910NH
The CPX−CM−HPP module documented in this description is
intended exclusively for use in Festo CPX terminals for
installation in a machine or an automation technology
system.
The CPX−CM−HPP, in combination with a controller, permits
independent control of up to four drives via CAN bus.
The CPX terminal and the CPX−CM−HPP is only to be used as
follows:
As intended in an industrial environment.
In its original condition without unauthorised
modifications. Only the conversions or modifications
described in the documentation supplied with the product
are permitted.
In perfect technical condition.
Only in combination with permitted components.
An overview of the supported motor controllers can be
found in Tab. 1/4.
The limit values specified for pressures, temperatures,
electrical data, torques etc. should be observed.
Observe the regulations of the trade associations,
German Technical Control Board (TÜV),
VDE specifications or relevant national regulations.
VII